Appro SD-7800 Guía de instalación descargar pdf (Pagina 4)

2 7800 Series Keypad Installation Guide

Touchscreen Display

The 7800 Series keypads have an integrated LCD touchscreen user interface. The

display can be set up to display a custom logo image on the main screen. See the

Custom Dealer Logo section below. The display can also be programmed to turn

off (blank screen) during periods when the keypad is not in use. See Backlighting

Brightness under End-User Options.

Warning: DO NOT use any sharp objects to operate the touchscreen such as a pen or

pencil.

Cleaning the Touchscreen Display

Select the keypad option from the main carousel menu until it glows and clean the

touchscreen using a water dampened soft, lint-free cloth. Apply the water onto

the cloth, do NOT apply directly onto the touchscreen. After cleaning, wipe the

touchscreen dry with a soft, lint-free cloth. Touch the back arrow before returning to

the main screen.

Micro SD Card

The 7800 Series keypads provide a spring-loaded Micro SD card slot on the right edge

of the keypad housing. This is used to load a custom logo onto the main screen. Insert

the Micro SD card straight in, with the contacts facing the wall, pressing in until a

click occurs from the spring mechanism. To remove the Micro SD card, gently press in

to allow the spring to eject the card. Grasp the edges of the card with two ngers

and remove.

Custom Dealer Logo

To display a custom dealer logo on the main screen, contact DMP Marketing at

1-800-641-4282 or [email protected] for information. To add a custom dealer

logo, see the Dealer Logo option under Installer Options menu.

Installing the Keypad

All DMP keypad housings are designed to easily install on any

single-gang switch box or at surface. Figure 6 shows the keypad

housing base mounting hole locations.

Remove the Cover

The keypad housing is made up of two parts: the cover, which

contains the circuit board and components, and the base. Use the

following steps and gures to separate the keypad cover and base:

1. Insert a at screwdriver into one of the slots on the bottom of

the keypad and gently lift the screwdriver handle toward you

while pulling the halves apart. Repeat with the other slot.

2. Using your hands, gently separate the front from the base and

set the cover and components aside.

Micro SD

Card Slot

ARMED

TODAY

WEDNESDAY

Panic

Chime

Check-in

Reset

MON 5:35 AM

CURRENT

HI LO

98 77

Figure 2: Micro SD Card Slot

Graphic

Keypad

Building Wall

Insert small

screwdriver and

lift to remove

cover.

Do not twist.

Figure 3:

Removing the

Keypad Cover

1 2 3 4 5 6 7 8 9 ... 21 22

Comentarios a estos manuales

Sin comentarios

Appro SD-7800 Guía de instalación Pagina 4

Comentarios a estos manuales