search

Appro SD-7800 Guía de instalación Pagina 16

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 22
  • Tabla de contenidos
  • MARCADORES
    • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 15
14 7800 Series Keypad Installation Guide
Restart Keypad
The Restart Keypad screen allows the installer to
restart the keypad to initiate a rmware update
from a Micro SD card.
Updating Firmware using Restart
1. Insert a Micro SD card into the Micro SD Card
Slot of a computer.
2. Locate and download the rmware update
RU le from dmp.com/dealer_direct and save
it to the root directory of the Micro SD card.
3. Insert the Micro SD card into the Micro SD card
slot on the right side of the 7800 Series keypad.
4. Enter the Installer Menu (3577), choose KPD OPT and press CMD to the new
Restart Keypad screen just after Select Language.
5. Press RESTART. The keypad will load the new rmware from the Micro SD Card
and then the keypad automatically restarts. Caution, do not remove the Micro
SD card or disrupt power during this process.
6. When the keypad restart is complete, remove the Micro SD card from the
keypad.
Accessing Keypad Diagnostics
If necessary, refer to Access the Options Menu earlier in this document.
KPD KPD
OPT DIAG STOP
Keypad Diagnostics (KPD DIAG)
This option displays Zone Test.
Z1 OPEN Z2 OPEN
Z3 OPEN Z4 OPEN
Zone Test
This option allows the keypads to display the current
electrical status of the four protection zones. The status
is shown as OPEN, SHRT, or OKAY.
Note: The Zone Test displays on other keypads without
built-in zones, but is not operational.
INPUT WIEGAND
Input Wiegand
This option tests the internal and external reader input
from proximity credentials. The display shows OKAY each
time a good proximity read is received.
Exiting the Installer Options
Press the CMD key until the display returns to the Installer Options screen. Select
STOP to exit the Installer Options function.
CMD
RESTART
Press the button to restart the keypad.
To load new rmware from an SD card, insert the card and
press RESTART. The keypad will restart, install, and restart
again. Do not remove the SD card or disrupt power during
this process.
RESTART KEYPAD
2GB
MICRO
SD
MON 5:35 PM
Figure 18: Restart Keypad
Screen
Vista de pagina 15
1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22

Comentarios a estos manuales

Sin comentarios
  • Jotul Bauer-gear-motor VidPro Embertec Avue
  • OmniMount Soportes De Pared Para Pantalla Plana PowerDsine Splitters De Vídeo Exakta No Archos Tabletas Black & Decker Los titulares
  • Billy Goat BG1002SP HP OMEN - 15-dc0086nr Georgia-pacific Engineered Lumber Cisco Catalyst 2900 Series XL Pioneer DV-535
  • Trendnet TK-205I Manual de usuario Panasonic NN-S235MF Manual de usuario Vixen Sphinx SXP Manual de usuario Makita BSS500 Manual de usuario Canon XA35 Manual de usuario